Cladding sheets and plates

When finishing the surfaces of walls and partitions are widely used cladding plates and sheets, which are obtained on the basis of polymers and mineral binders.

Gypsum sheathing sheets (plasterboard) used for interior surfaces in all areas where the operating conditions humidity does not exceed sixty percent. At the highest humidity sheetrock warp, come unstuck from the mastic, sometimes blistering, adhesion of gypsum board must be hard to board with his hands tearing stratified and not come unstuck. The surface of these sheets must be flat, smooth, and the front side should be without strain cardboard strips and patches.




Cladding sheets with colored enamel coatings or decorative pasting used for surface finishing.



Sheets of gypsum plaster over do not have a paper shell and look like thin gypsum board with fiber additives that increase the strength of plates. Front surface of the sheet tends to be ofakturennoy, smooth or rough.



Fiberboard sheathing used as cladding and insulation. These boards are produced by pressing of wood or other vegetable fibers doped with specific products that increase the mechanical strength and give them the biological stability. Today made the following types of fibreboard: high quality design, solid - for finishing floors and walls to cover with the painted surface, simple - no surface treatment.

Plates for the walls are of two kinds: for lining wet and dry areas for tiling. For dry rooms available plates, the front surface of the emulsion painted enamels. Color of tiles: dark blue, light blue, light blue, light blue, pistachio, cream, ivory and white. For wet rooms available plates impregnated with water-resistant synthetic resins. Their texture is a relief, and the surface is colored melamine enamels. Color: light blue, light green, green. The surface must be smooth, even, no oil stains.



Paper and plastic laminated decorative sheet material is also obtained by hot pressing special papers, which are impregnated with polymers. To impregnate his inner layers of the binder is a phenol-formaldehyde resin, and for the outer layers - urea transparent resin.